A branch tee introduces a connection to a main line or machine port while routing tubing to two locations. It is useful for distributing compressed air or vacuum near equipment.

Branch and run tees position the threaded connection differently relative to the two tubing outlets. Select the geometry that best matches the orientation of the machine port and tube runs.

BPB06-U01 is specified for 6 mm outside-diameter tubing and a 1/8 Thread port connection. Both tubing outlets use the stated tube size unless the product is specifically identified as reducing.

Make sure each line is sized for the required flow, leave space to operate the release collars and avoid sharp bends or mechanical loads on the threaded port.

The published all-metal B-Series range is specified for compressed air and vacuum service, subject to compatible tubing, proper sealing and the limits of the assembled system. Other fluids need separate compatibility confirmation.

The published fitting-family limits extend from full vacuum to 176 psi (12 bar, as listed for the fitting family), with a fitting temperature range of -40 to +248 °F (-40 to +120 °C). Actual system limits also depend on tubing, seals and installation; do not treat these as fluid-compatibility certifications.