The SE5/32 has 3 push-to-connect sockets for the same 5/32" (nominal 4 mm) tube outside diameter and no threaded port.

No. The fitting only provides a junction; the source, tube internal diameter and pressure loss still determine available flow. Extra branches can increase aggregate demand and leakage risk.

No. 5/32 in is 3.96875 mm, not precisely 4 mm. The catalogue may show a nominal cross-reference; confirm allowable tube outside-diameter tolerances before substituting tubing.

Pneuforce lists this stainless push-to-connect family for compressed air and vacuum. The completed connection must use compatible tubing with a clean, undamaged outside surface, and the system must be checked for leakage at its operating vacuum.

Do not assume potable-water approval. Pneuforce lists these push-in fittings for compressed air, vacuum and non-potable water; drinking-water or food-contact approvals would require separate documented certification.

FKM is the fluoroelastomer sealing material used in this fitting family. It is chosen for resistance to many oils, chemicals and elevated temperatures, but exact media compatibility depends on the fluid concentration, temperature and seal formulation.

Match the tube outside diameter and approved tubing material to the fitting. Cut squarely, remove burrs, insert fully and check retention and leaks before putting the system into service. Confirm the connection can be disconnected safely after depressurizing.