Product Overview

The ZFC200 is intended as a service part for the ZFC7 filter size. In a point-of-use vacuum circuit the element traps dust and particulates before they enter the vacuum generator or pump. Replacing an obstructed element can help restore flow and reduce unwanted restriction.

The filter housing, tubing connections and mounting bracket are not supplied as part of this replacement element. Select the element by the existing filter body size, not simply by the outside tubing diameter.

Technical Specifications

Maintenance and replacement

Isolate the vacuum circuit, relieve pressure and open the ZFC7 filter housing according to its service procedure. Remove the used element, inspect the bowl and seals, install the correct replacement and check for vacuum leaks before restarting.

A clogged element increases restriction. The inspection interval depends on product dust, process debris and cycle frequency; visible contamination or declining performance indicates the need for service.

Typical Applications

Routine maintenance of pick-and-place suction circuits, robotic end-of-arm vacuum manifolds, packaging machines and other machinery using inline vacuum filtration.

Frequently Asked Questions

Selection note: Confirm connections, actual operating conditions and required holding force or filtration performance before final installation. Vacuum generator flow and compressed-air consumption are different measurements; ratings shown are under the published test conditions.